The SweatMiser processor board displays readouts for Relative Humidity, Dewpoint, Percent Savings and Store Temperature. Each of these values are updated approximately every 5 seconds.

Humidity

Displayed as %RH, this readout is adjustable by turning the Relative Humidity Sensor Calibration Dial Simply use a sling Psychrometer or an accurate electronic RH sensor to establish the store RH near the location of the installed RH sensor. Adjust the
pot until the SweatMiser readout matches the sling readout.

Dewpoint

The SweatMiser calculates Dewpoint using the RH and temperature sensor inputs and a built-in psychrometric chart. Dewpoint is displayed as °F and is used to determine the pulse rate to the solid state relays.

Percent Savings

This display shows the energy savings accomplished by the SweatMiser at that instant. The percentage is calculated from the pulse rate being sent to the solid state relays. For example, if the relays are being cycled ON 6/10 of a second and OFF for 4/10 of a second, the savings would be 40%. A 0-5 VDC analog output is provided for optional remote monitoring by electronic
equipment.

Temperature

The integral 10 k ohm thermister located in the combination humidity/temp sensor provides the current store temperature in degrees Fahrenheit. If required, this readout may be calibrated using the Temperature Sensor Calibration Dial.

Download the complete specifications and installation manual by clicking here.